About PADS transfer documents note

As the Pads file transfer gerber controversial, after finishing the customer record and customer record, it is easy to make controversial place to make uniform rules:

1. As shown in Figure 1 arrow "1" refers to the options as long as there is ticking and have put on the color will be transferred out, there is no tick and check the color is black do not turn.

2. As shown in Figure 1 arrow "2" refers to the layer by line, solder mask, characters, sub-hole map, drill belt turn out, (necessary layers, such as circuit layer, please open, if the layer is off, Can not turn out, or the display is black, do not turn this layer.

3. PADS / POWERPCB defined layer name represents the layer.

Top: Top line Bottom: Bottom line

Solder mask Top: Top Solder mask Bottom: Bottom solder mask

Silkscreen Top: Top Silkscreen Bottom: Bottom silkscreen.

Drill Drawing: hole chart (general shape, hole characters, holes, attributes are reflected in this figure)

NC Drill: Drilled layer

Four-layer board, there will be the inner layer, such as LAYER2 said the inner second layer, LAYER3 said the inner third layer. Six-layer pcb board and so on.